Equation: log(inhibitor) vs. response  Variable slope 

Equation: log(inhibitor) vs. response  Variable slope 


This equation is used when X values are logarithms of doses or concentrations. Use a related equation when X values are concentrations or doses.
Many log(inhibitor) vs. response curves follow the familiar symmetrical sigmoidal shape. The goal is to determine the IC50 of the inhibitor  the concentration that provokes a response half way between the maximal (Top) response and the maximally inhibited (Bottom) response.
Many inhibitory doseresponse curves have a standard slope of 1.0. This model does not assume a standard slope but rather fits the Hill Slope from the data, and so is called a Variable slope model. This is preferable when you have plenty of data points. It is also called a fourparameter doseresponse curve, or fourparameter logistic curve, abbreviated 4PL.
Create an XY data table. Enter the logarithm of the concentration of the inhibitor into X. Enter response into Y in any convenient units. Enter one data set into column A, and use columns B, C... for different treatments, if needed.
If you prefer to enter concentrations, rather than the logarithm of concentrations, use Prism to transform the X values to logs.
From the data table, click Analyze, choose nonlinear regression, choose the panel of equations "Doseresponse curves  Inhibition" and then choose the equation "log(inhibitor) vs. response  Variable slope".
If you have subtracted off any basal response, consider constraining Bottom to a constant value of 0.
Y=Bottom + (TopBottom)/(1+10^((LogIC50X)*HillSlope))
IC50 is the concentration of agonist that gives a response half way between Bottom and Top. This is not the same as the response at Y=50. Depending on which units Y is expressed in, and the values of Bottom and Top, the IC50 may give a response nowhere near "50". Prism reports both the IC50 and its log.
HillSlope describes the steepness of the family of curves. A HillSlope of 1.0 is standard, and you should consider constraining the Hill Slope to a constant value of 1.0. A Hill slope more negative than 1 (say 2) is steeper.
Top and Bottom are plateaus in the units of the Y axis.